ext_74: Baron Samadai in cat form (Default)
silicon_shaman ([identity profile] siliconshaman.livejournal.com) wrote in [personal profile] maradydd 2009-02-09 01:46 am (UTC)

Depends on the printer, but I think the typical heater voltage is between 50 to 150volts. I.e, right in the range needed. [which is why I thought of it.] Starting from 12volts input.
(102 comments)

Post a comment in response:

If you don't have an account you can create one now.
HTML doesn't work in the subject.
More info about formatting

If you are unable to use this captcha for any reason, please contact us by email at support@dreamwidth.org

 
Notice: This account is set to log the IP addresses of everyone who comments.
Links will be displayed as unclickable URLs to help prevent spam.